I am testing a critical auth VLAN config but it looks like I it is not working. The port has a phone and then a PC attached to the phone. Config is below. What happens is that the PC will still get an IP on VLAN 429 (even after ipconfig renew or port...
Hi Team, Is there an ETA when to expect Base licensing to be term based? Thank you!
Hi all, An FlexConnect AP is authenticated via 3650/3850 SW 16.x against ISE 2.3 with multi-host mode and there is the default ACL on the interface allowing only DHCP/DNS traffic before succesfull AuthC/AuhtZ. Is it possible to allow any communicatio...
Currently customers SOA server accepts the data in JSON format and below is the sample format that their server can accept : POST https://<<IP>>:<<PORT>>/ENS/v1/SMS HTTP/1.1Accept-Encoding: gzip,deflate [Required, constant]APIKEY: XYZ12345 [Required,...
Hi, I run ISE 1.3 for Wireless, I will be creating a new SSID on my WLC's for a specific amount of users who will be authorised by MAC authentication using ISE. Basically I will have a list of about 50 mac addresses that will be held on the ISE. Us...
I want to upgrade the ACS from ACS 5.6 to ACS 5.8. Current Version: 5.6.0.22.5 Plan Upgrade to ACS_5.8.0.32.tar.gz Patch 5-8-0-32-10.tar.gpg I know there are additional steps involved- like de-register, change the log server, and so on. I just want t...
helloi have ise 2.0 and mse 8.0.150.0 , when i add MSE to ISE i get this error ."No response. Network error or invalid IP address" i completed all of the configuration about Cisco prime , WLC and MSE . all of them working and no problem with each o...
Hello folks,I wonder what I have to do in ISE to enable it sending SMS when activating a new guest account. I believe there must be a corresponding setting somewhere under Web Portal Management to configure SMS gateway neither under Global system set...
Hello All, An IP Phone is coonected to a switch port enabled for ISE authentication. IP device tracking autosource is enabled, but still we are not able to see the IP address while doing "sh auth sessions" on the switch. Could anyone please help me...
Using Cisco ISE 2.3, how to setup device authentication(AAA) services with MFA(PortalGuard) PortalGuard is integrated with Active directory so we need different authorization polices for AD users/groups as required.
Hello Cisco Community I have a simple topology of LAN network, everything works great excepted my Radius server !So, here is my topology : My problem is when I try to do connection attempt to the router R1 from Administrateur via SSH, the authentica...
Do the two servers in a small deployment have to be the same size? I have a customer who is setting up a lab and they have one small VM and one medium VM license, can they build a small deployment with VMs that aren't sized the same? Since it's a l...
New with Cisco ISE 2.4 Able to go though and setup Certificate Provisioning Portal However BYOD i cant get it to work When I test the portal page and click start I automatically get error Your device is currently unsupported. Then i click retry ...
Dears, I deployed distributed ise nodes with five nodes.The two nodes are pan and three nodes are psn.but now I have two primary active pan and I can`t remove any of them. May you please help me to remove one of them or change it to secondary pan.
The specific problem at hand: I'm trying to use ISE's ERS system with PostMan to pull the details of a specific end-point. The overall goal: Use ERS to pull a list of successful RADIUS authentications where a specific policy is applied. Then, pull t...
