IOSvL2 not starting any kind of authentication

[abhisheks]

Hi, 

I'm using VIOS L2 version -Version 15.2(4.0.55)E. On this, DOT1X or any kind of authentication is not even starting on the switch. I've attached the full switch config, and I'm pretty it is correct. Of course the interface is up and the switch can reach the ISE server, but the authentication "process" is not initiating at all. 

The Windows host connected to the switch can browse the internet successfully, so the NIC is also up on the Windows host. I'm not worried about DOT1X etc, as that would be secondary, but any form of authentication is not even beginning on this switch. Any ideas? 

I've attached the switch config. 

[howon]

I suggest contacting VIRL team regarding authentication support.

[Arne Bier]

Hello @howon 

This is an old thread, but do you recall what the answer was from the VIRL/CML team? I ran into the same issue today with the latest CML 2.1 image of IOSvL2

Cisco IOS Software, vios_l2 Software (vios_l2-ADVENTERPRISEK9-M), Experimental Version 15.2(20200924:215240) [sweickge-sep24-2020-l2iol-release 135]