06-10-2024 10:00 PM
Hello,
I've updatet a small deployment (2 sns3615) to version 3.3 patch 2, and now I get temporarily no snmp Data from the primary node.
On secondary and on a virtual Test machine everything's fine.
On every node the same running config (snmp, timezone)
I've already disabled snmp and reconfigured, made a reboot.
It looks like this:
is there any command on the cli to find only snmp Log?
I only use polling, no trap, before the Upgrade with v 3.2 patch 6 everything was fine
Solved! Go to Solution.
06-23-2024 10:58 PM
Just for Info:
After Firmware-Upgrade of the SNS-3615 to 4.3.2 everything is fine
06-10-2024 10:17 PM
If you run manual SNMP walk commands during those times, do you get any responses? Does your NMS show continuous availability (e.g. via ping) during those gaps?
Is the CPU on the Primary unusually high?
I'd go directly to the TAC with this.
06-11-2024 12:08 AM
Hello Arne,
snmpwalk from another Monitoringdevice is ok, ICMP is ok, CPU is not high but memory (85%), but I've read this would be normal.
I will contact our Support-Partner
06-23-2024 10:58 PM
Just for Info:
After Firmware-Upgrade of the SNS-3615 to 4.3.2 everything is fine
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide