ISE Admin Access Authentication against multiple AD/LDAP Identity Sources
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-12-2013 05:43 AM - edited 03-10-2019 08:32 PM
Hi all!
We would like to grant admin cccess to our ISE deplyoment to users stored in multiple Active Directories. Since there is no trust relationship between these ADs, we created an LDAP Identity Source for each AD and also an Identity Source Sequence but in the UI we can only select one Identity Source.
Any ideas how to solve this problem?
Thanks in advance!
Kind regards,
Michael Langerreiter
- Labels:
-
AAA

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-12-2013 06:05 AM
I did check in my lab and yes for admin access we can't select identity store sequence in authentication. We can only pick one external database. However, on the login page you may select the appropriate database before you enter the username and password.
Jatin Katyal
- Do rate helpful posts -
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-12-2013 06:12 AM
I selected one of the identity sources.
The Dropdown-Box in the Login Page now contains the "Internal" Identity Source an the previously selected LDAP Identity Source, but not more than these two.
Michael Langerreiter

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-12-2013 04:24 PM
I have only AD1 configured and it shows internal and AD1 for me too. I will add one more tomorrow may be LDAP and test again. Will keep you updated.
Jatin Katyal
- Do rate helpful posts -
