cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
17729
Views
13
Helpful
8
Replies

ISE Admin node Replication error

Rafael Mendes
Level 2
Level 2

Hello Everyone,

I receive this alarm some times:

Alarm

Occurred At:Wed Mar 20 09:20:10 BRT 2013
Cause:Replication Stopped
Details:Replication Stopped for the host PANVMGP3301B(Secundary Admin node)

Today i go to Administration -> System -> Deplyment and i can see my secundary Admin/Monitoring node with status "REPLICATION DISABLED" see the attach image.

I can force the sync for the Primary and Secundary Admin Nodes? How i can fix this?

Tks!

1 Accepted Solution

Accepted Solutions

nspasov
Cisco Employee
Cisco Employee

Yes, something prevented your nodes from staying in sync and as a result, the nodes stopped trying to syncup. You will need to manually sync the nodes. Go to Administration > Deployment. Then select/check all of the nodes and click on the "Syncup" button above the personas.

Thank you for rating!

Thank you for rating helpful posts!

View solution in original post

8 Replies 8

nspasov
Cisco Employee
Cisco Employee

Yes, something prevented your nodes from staying in sync and as a result, the nodes stopped trying to syncup. You will need to manually sync the nodes. Go to Administration > Deployment. Then select/check all of the nodes and click on the "Syncup" button above the personas.

Thank you for rating!

Thank you for rating helpful posts!

Hi Neno,

Ok, now its working fine!

Thank you!

Good to hear!

Thank you for rating helpful posts!

Go to Administration > Deployment. Then select/check all of the nodes and click on the "Syncup" button above the personas.

Hi,

I have two nodes, 

the 1 st one  is OK ==> Pri (A) and Sec (M),

the Second is not sync  ==> Sec (A) and Pri (M).

when I want to sync it i have this message : 

Error : unable to load/admin/syncup Action.do?command=syncup DB status:12002

my problem happend after an uprgre from ver 2.0.3 to 2.3

Can you help me,

 

When i performe the sync I check only yhe ISE who had the warning and i click syncup.

In your prevous reply you ask to check all ISE (Then select/check all of the nodes and click on the "Syncup" button above the personas.)

 

When i performe the sync I check only yhe ISE who had the warning and i click syncup.

In your prevous reply you ask to check all ISE (Then select/check all of the nodes and click on the "Syncup" button above the personas.)

 

So, What is the solution ?

You advice manuel syncronize but as you know this is not the solution for root cause...

What is reason for tis case and what is real solution ?

Thanks ..

Ugur DUMAN