ISE - How to export endpoint database with all attributes?

[mini]

Hi

I need to compare unit attributes captured from the different probes.
If I go to "Context Visibility" -> "Endpoints" -> "Export" I get a database (CSV) that misses most of the various attributes.
Is there a way to extract all the information?

ISE runs 2.7.

[Mohammed al Baqari]

Hi,

Have you tried to go reports > diagnostics > endpoints. See if this
fulfill your requirement.

***** please remember to rate useful

[CarlCarlson1234]

If you have access to use it, try the ISE Endpoint Analysis tool by Cisco.  Or an endpoint dump from the admin cli might have the attributes you're looking for,   application configure ise, option 16.

[Damien Miller]

The Cisco EAT tool is the ideal candidate for this, I tend to have a lot of problems trying to run it myself. If you can get it to work and it doesn't crash, then it probably has the attributes the OP is after.  

Not sure if it is publicly accessible though.

https://iseeat.cisco.com/

[martin.fischer · Accepted solution]

Hi @mini 

SSH into your ISE and enter the command 'application configure ise'. There you have the option 'Get all Endpoints'. This creates a CSV with most of the information available.