ISE HW model

[Gioacchino]

Hi all,

what's the way to check the hardware model the ISE runs on?
I don't seem to find this info on the GUI.

Gio

[DanielP211 · Accepted solution]

Hello,

You can use the command:
show inventory

But if the appliance is installed on a virtual infrastructure you wont see much.

BR

[Gioacchino]

Thanks @DanielP211 ,

yes, it's indeed an appliance.

Thank you,

Gio

[Gioacchino · Accepted solution]

@DanielP211,

also in the GUI, Administration -> System -> Licensing

[craiglebutt]

You will need a VM Licences as well to run ISE on VM

Cheers

[Gioacchino]

Thanks @craiglebutt ,

was your intention to reply in this post ?
https://community.cisco.com/t5/network-access-control/yaiu-yet-another-ise-upgrade-question/td-p/4887685

Gio

[Greg Gibbs]

From the GUI, you can find what platform ISE identifies each individual node as from the ISE Counters report found in Operations > Reports > Diagnostics > ISE Counters
This will work for both hardware and VM platforms.

Example from my instance in Azure (this profile equates to the extra small instance type used for Eval):