ISE Live Authentications Not Visible

[manglen32]

Hi,

I have a single node ISE deployed and have been adding and deleting policies for the past two weeks without issue.  It's using our production AD and CA server and connected to NCS.  My problem is that today when I was working on a new MAB policy, the policy would let the laptop on the network, but nothing appeared in live authentications screen or the reports.  I tried this with both a MAB and 802.1x policy set and both times I logged on with the correct policy, but nothing was showing in the logging.  These were both wireless and I had both the authentication and the accounting pointing at ISE.  As well as SNMP too.

I forgot to see if the clock was off, but if the authentications are working, I'm not sure why the reporting is not.

Any help would be appreciated.

Thanks,

Mike                  

[huangedmc]

Is your log target set up?

Admin/System/Logging/Remote Logging Targets/LogCollector

Also if this is a guest wifi setup between a Cisco foreign & anchor WLC, make sure Auth & Accounting are set up on the foreign WLC.

[John Mutama]

Use the show application status ise to confirm if the Log processor is running.

ISE M&T Log Processor is not running.

use the application "stop" and "start" ise. command to start the process