cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
435
Views
5
Helpful
4
Replies

ISE Live Authentications

Roger Alderman
Level 3
Level 3

I have ISE with latest version 1.2.1.198

I never see any entries in the live authentications page even though I have clients successfully authenticating and being authorised.

Different browsers seem to make no difference.

Has anyone also seen this and has anyone found a bug relating to this?

 

Regards

Roger

 

1 Accepted Solution

Accepted Solutions

Venkatesh Attuluri
Cisco Employee
Cisco Employee

make sure your NAD is configured correctly . and try

ms-ise-mgm01/admin# app config ise

Selection ISE configuration option
[1]Reset Active Directory settings to defaults
[2]Display Active Directory settings
[3]Configure Active Directory settings
[4]Restart/Apply Active Directory settings
[5]Clear Active Directory Trusts Cache and restart/apply Active Directory settings
[6]Enable/Disable ERS API
[7]Reset M&T Session Database
[8]Rebuild M&T Unusable Indexes
[9]Purge M&T Operational Data
[10]Reset M&T Database
[11]Refresh M&T Database Statistics
[12]Display Profiler Statistics
[13]Exit

try

7 to reset the session db
10 to reset the M&T database

Once you have run these commands the DashBoard should begin to display information.

 

View solution in original post

4 Replies 4

nspasov
Cisco Employee
Cisco Employee

Silly question but do you have the ISE servers configured as "accounting" servers in your NADs?

 

Thank you for rating helpful posts!

Yes I have the ISE Servers configured as accounting servers.

Venkatesh Attuluri
Cisco Employee
Cisco Employee

make sure your NAD is configured correctly . and try

ms-ise-mgm01/admin# app config ise

Selection ISE configuration option
[1]Reset Active Directory settings to defaults
[2]Display Active Directory settings
[3]Configure Active Directory settings
[4]Restart/Apply Active Directory settings
[5]Clear Active Directory Trusts Cache and restart/apply Active Directory settings
[6]Enable/Disable ERS API
[7]Reset M&T Session Database
[8]Rebuild M&T Unusable Indexes
[9]Purge M&T Operational Data
[10]Reset M&T Database
[11]Refresh M&T Database Statistics
[12]Display Profiler Statistics
[13]Exit

try

7 to reset the session db
10 to reset the M&T database

Once you have run these commands the DashBoard should begin to display information.

 

Roger Alderman
Level 3
Level 3

This did the trick.

Thanks very much for the pointer.