ISE "authentication host-mode multi-host" config problem in 2960X

[rezaalikhani]

Hi all;

Please consider the following figure:

As you can see, these are two separate authentication methods on the same interface. In this scenario, the PC is connected to a non-Cisco IP Phone and the phone is connected to the switch. As you see above, the switch considered the PC as in "VOICE" domain!

The actual configuration of the interface is as follows:

The switch is Catalyst 2060X with Cisco recommended IOS on it (152-7.E7).

Any ideas?

Thanks

[MaErre21325]

HI @rezaalikhani ,

i think you have to configure:

authentication host-mode multi-domain

let me know if works

bye

[rezaalikhani]

Thanks for your reply;

I will give your suggestion a try but I do not understand this behavior on my switch.

[MHM Cisco World · Accepted solution]

The ISE reply with voice domain for both pc and phone

I. E. You not config two differ authz profile 

[rezaalikhani]

You were right. Thanks

[MHM Cisco World]

You are so welcome Friend