- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-10-2020 01:12 PM
HI All
Please find the attached config
Pc is not getting the ip address
while opening the redirection url getting the below error
[ 400 ] Bad Request
The request is invalid due to malformed syntax or invalid data.
Possible cause is unknown, invalid, or terminated RADIUS session ID. Please advise the System Admin to consult the logs and ensure that the RADIUS session was not generated by a different PSN or due to a deny access policy match.
i have attached the config below
ise version is
ersion information of installed applications
---------------------------------------------
Cisco Identity Services Engine
---------------------------------------------
Version : 2.4.0.357
Build Date : Thu Mar 22 19:01:26 2018
Install Date : Sun May 10 10:26:07 2020
Solved! Go to Solution.
Accepted Solutions

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-10-2020 04:31 PM
From the switch config, it looks like you have 'ip dhcp snooping trust' configured on the client port rather then the trunk port. This command should be removed from the client port and configured on the the trunk port where the response from your upstream DHCP server will be seen.
Also be sure you have an 'ip helper-address' configured on the upstream L3 interface if your DHCP server is on a different subnet.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-10-2020 01:40 PM
Portal is working after recreating the certificate but the machine is not getting ip i have given static ip it works
Please can any open help on ip past

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-10-2020 04:31 PM
From the switch config, it looks like you have 'ip dhcp snooping trust' configured on the client port rather then the trunk port. This command should be removed from the client port and configured on the the trunk port where the response from your upstream DHCP server will be seen.
Also be sure you have an 'ip helper-address' configured on the upstream L3 interface if your DHCP server is on a different subnet.
