Solved: ISE: reset whole ISE back to factory configuration

naoki_Japan · ‎10-25-2021

the command "application reset-config ise" will reset ISE to factory configuration.

this time, I wanna reset the configuration of whole ISE (I mean CIMC, ADE and ISE) back to factory configuration since there is a problem I can not fix.

Tell me the procedure or reference web pages, please.

naoki_Japan · ‎10-25-2021

The problem I had was disability of ADE OS, which caused error of backup of configuration data.

As a last resolution, I issued the command "reset-config", and solved the problem.

thank you for your active support as always!

View solution in original post

marce1000 · ‎10-25-2021

>....since there is a problem I can not fix

It's always better to then, describe that in your (initial) post too.

M.

-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '

naoki_Japan · ‎10-25-2021

The problem I had was disability of ADE OS, which caused error of backup of configuration data.

As a last resolution, I issued the command "reset-config", and solved the problem.

thank you for your active support as always!

victormanuelsolis · ‎07-13-2022

reset-config command reset the GUI configuration as well?

Marcelo Morais · ‎07-13-2022

Hi @victormanuelsolis .

question answered at Cisco ISE Factory Reset.

Regards