ISE Secure Client compliance module

[Ib_Reda]

Hello

I downloaded and installed ISE Secure Client compliance module on my PC manually,  but it has not been added to AnyConnect. how can I add it to anyconnect as below:

Also, in compliance scenario, the below configuration must configure or the below for "non-compliance and unknown ":

• AnyConnect / Secure client Posture profile
• Upload AnyConnect file packages
• Download automatic or upload offline ISE Compliance package
• AnyConnect Configuration
• Client provisioning

I am meaning, if i confirmed that windows FW enabled and patch is up to date , then I installed ISE compliance module manually on my PC -----> only i need Posture policy and access policy, i am not needed to apply the steps mentioned before, this is right?

[ahollifield · Accepted solution]

You also need to the install the ISE Posture Module.  

https://community.cisco.com/t5/security-knowledge-base/ise-posture-prescriptive-deployment-guide/ta-p/3680273

https://www.cisco.com/c/en/us/products/collateral/security/anyconnect-secure-mobility-client/anyconnect-secure-mobility-client-v4x-eol.html

[Ib_Reda]

Thanks noted