ISE with Multiple Interfaces

[scottbreslin]

Hi,

I have a requirement to deploy an ISE appliance into a customer environment where the management network is separate from the data network.

I understand that GEth0 is dedicated for management access to ISE so, I can assign an IP address to this interface form the management network.

What I don't understand is how I configure Geth1 for authentication traffic such as radius requests.

After I have assigned an IP address to GEth1 from the data facing network how do I tell ISE to use this interface for authentication requests?

Unless I have missed something this does not seem to be documented.

Thanks

Scott    

[ahollifield]

Depends.  Does this match what you need in your environment?  https://community.cisco.com/t5/security-documents/how-to-ask-the-community-for-help/ta-p/3704356

I would HIGHLY suggest making a new post versus commenting on a post from 2017.