08-06-2017 02:14 PM - edited 03-11-2019 12:55 AM
Hi,
I have a requirement to deploy an ISE appliance into a customer environment where the management network is separate from the data network.
I understand that GEth0 is dedicated for management access to ISE so, I can assign an IP address to this interface form the management network.
What I don't understand is how I configure Geth1 for authentication traffic such as radius requests.
After I have assigned an IP address to GEth1 from the data facing network how do I tell ISE to use this interface for authentication requests?
Unless I have missed something this does not seem to be documented.
Thanks
Scott
Solved! Go to Solution.