cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

This community is for technical, feature, configuration and deployment questions.
For production deployment issues, please contact the TAC! We will not comment or assist with your TAC case in these forums.
Please see How to Ask the Community for Help for other best practices.

1668
Views
6
Helpful
2
Replies
Highlighted
Cisco Employee

Juniper EX Switches - NAD Profile

This is a question I received in email. Posting it here for everyone to benefit.

Q: Juniper EX Switch does not send service-type, so how can ISE detect a MAB versus an 802.1X authentication.

A: Attaching a screen shot & a NAD profile for ISE 2.0+.

Note: As of the time of this posting, Juniper EX switches were not tested by the ISE QA team & therefore are not listed in the compatibility matrix here:  Cisco Identity Services Engine Network Component Compatibility, Release 2.0 - Cisco

2016-04-19_13-21-19.png

2 REPLIES 2
Highlighted
Beginner

Has there been any added support in ISE 2.3 for the Juniper access switches?  We have roughly 1500+ Juniper 4200 access switches deployed and my hopes are to get wired access control setup as well as TACACS for device administration.

Highlighted
Beginner

Is there guide how to configure redirection on Juniper EX for ISE Posturing on the switch?