Juniper EX Switches - NAD Profile

[Aaron Woland]

This is a question I received in email. Posting it here for everyone to benefit.

Q: Juniper EX Switch does not send service-type, so how can ISE detect a MAB versus an 802.1X authentication.

A: Attaching a screen shot & a NAD profile for ISE 2.0+.

Note: As of the time of this posting, Juniper EX switches were not tested by the ISE QA team & therefore are not listed in the compatibility matrix here:  Cisco Identity Services Engine Network Component Compatibility, Release 2.0 - Cisco

[wwright00]

Has there been any added support in ISE 2.3 for the Juniper access switches?  We have roughly 1500+ Juniper 4200 access switches deployed and my hopes are to get wired access control setup as well as TACACS for device administration.

[misinsuan2229]

Is there guide how to configure redirection on Juniper EX for ISE Posturing on the switch?