09-10-2014 11:08 PM - edited 03-10-2019 10:00 PM
Does LANLITE switches support monitor mode? We can't seem to write the authentication open command under the interfaces.
Solved! Go to Solution.
09-11-2014 03:30 PM
At a min you need "LAN Base" to run that feature. You can check Cisco's "Feature Navigator" to confirm this and any similar queries in the future. I wasn't sure so that is what I used to find out :)
I also found this thread helpful:
https://supportforums.cisco.com/discussion/11078736/lan-lite-image-vs-lan-base-image
Thank you for rating helpful posts!
09-11-2014 03:30 PM
At a min you need "LAN Base" to run that feature. You can check Cisco's "Feature Navigator" to confirm this and any similar queries in the future. I wasn't sure so that is what I used to find out :)
I also found this thread helpful:
https://supportforums.cisco.com/discussion/11078736/lan-lite-image-vs-lan-base-image
Thank you for rating helpful posts!
09-16-2014 07:30 AM
FYI.. LAN lite is not recommended with ISE 1.2 (if you are planning for one)
05-21-2015 11:58 PM
good function!! thanks for all respondent!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide