Loss dynamic user when I upgrade ACS 4.0 to 4.1

[jose2r]

When I upgrade from an ACS from version 4.0 to version 4.1 statics users are saved but dynamic are not saved.

This problem was detected in cisco?

Is there a way to export the database from version 4.0 to be able to import a version 4.1.

I have a big problem because they are 700 users dynamic edited manually.

Thank you very much.

[vkapoor5]

Dynamically mapped users are not saved when you perform replication, upgrade or overinstall ACS. Dynamically mapped users are saved when you back up or restore ACS.

"Performing a Full Upgrade From ACS SE 4.0.1 to ACS SE 4.1":

http://www.cisco.com/en/US/docs/net_mgmt/cisco_secure_access_control_server_for_solution_engine/4.1/installation/guide/solution_engine/upgap.html#wp1111375

[jose2r]

The ACS is not an appliance, it's the same?

Thank you very much.

[Robert.N.Barrett_2]

Just wondering why you care about the dynamic users? I thought that once they try to authenticate again, they will be re-added to the database.