Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
When I upgrade from an ACS from version 4.0 to version 4.1 statics users are saved but dynamic are not saved.This problem was detected in cisco? Is there a way to export the database from version 4.0 to be able to import a version 4.1.I have a big pr...
Hello When you create an Ap-Group you are defined that SSID is going to belong to the AP-Group.I don't understand because they in the AP spread all the SSID that they is definite in the Lan controller, I understand that only should publish the SSIS ...
If you have an ACS aplliance and do you want to use a base of external data base Activate Directory, it´s necessary install an agent where it be been located the Activate Directory, If you have more Activate Directorys installed it in other machin...
I configured a two Router with multicast anf Hsrp,with the next commands:ip multicast-routinginterface GigabitEthernet1.X ( X=1,20,40,50) ip pim dense-mode ip cgmpThis configuration is simetric in the 2 Routers.The conection of this Routers is trou...
In lan controller I have this 3 SSID : SSID DATA SSID Voice SSID GuestI have defined and AP-group, called Enterprise with this: SSID DATA interface data SSID Voice interface VoiceIn the AP I have defined the ap-group name: AP-Group name: Enterprise...
Hello, When you erase de configuration, you erase all the configuration except the information about vlans.You can see the archives if you put de command dir, with this command you can see:Start-config, running-config .... and vlan.dat.If you erase v...
