08-15-2017 02:59 PM - edited 03-11-2019 12:56 AM
I was trying to work on cisco ISE MAB authentication with IOS device, and i reloaded the ISE server. I lost connectivity to to TTY and GUI post to that.
I did save the configuration before reloading. I even tried resetting the config, but nothing works.
08-16-2017 02:44 AM
Hi,
Are you able to ping the ISE IP?
Is it a VM installation or hardware device?
Regards,
Aditya
Please rate helpful and mark correct answers
08-16-2017 08:05 AM
Hi Aditya,
I am not able to ping the IP. Its a VM installation. When i give a continuous ping to the ISE IP, it doesnt ping, but when i restart the VM, the IP pings for a few seconds and then again its not reachable.
This makes it clear that there are no routing issues as i am able to ping. But, i dont understand the behavior of ISE as to why it is not reachable.
08-23-2017 02:21 AM
- You should reboot the ISE VM (again); follow the boot process from the (VM) console ; check for errors (if any)
M.
08-23-2017 12:55 PM
I have played in the lab with 1.2, 1.4, 2.2 VM's with no issues at all. BUT, before reloading the server I ALWAYS do: application stop ise, show application status ise (verify everything is stopped), then reload the server.
Please also check that you have enough resources when the VM was initially configured. In any case, I would recreate it.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide