cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
449
Views
0
Helpful
4
Replies

mac address bypass and recovery

CSCO11968887
Level 1
Level 1

switch:c2960-48TC-L IOS Version 15.0(2)EX5
Radius ACS3.3

aaa authentication dot1x default group radius
aaa accounting dot1x default start-stop group radius

radius-server host 10.0.0.13 auth-port 1812 acct-port 1813 key 7 xxxxxxxxx

interface FastEthernet0/9
switchport mode access
authentication event server dead action reinitialize vlan 1
authentication event server alive action reinitialize
authentication host-mode multi-auth
authentication order mab
authentication priority mab
authentication port-control auto
authentication periodic
authentication timer reauthenticate 60
mab
spanning-tree portfast

i only use MAB not use 802.1X and MAC passed MAB authentication,
when RADIUS server becomes unavailable , i hope MAC bypass and don't disconnect session,after into Critical VLAN
when RADIUS server becomes available from unavailable , i hope Critical VLAN auto return to common VLAN and don't disconnect session
can MAB  do it ?

i try following command but fail
authentication event server alive action reinitialize
authentication recovery delay 1

1 Accepted Solution

Accepted Solutions

nspasov
Cisco Employee
Cisco Employee

Hi there, can you try the following instead:

authentication event server dead action authorize vlan <your VLAN>
authentication event server alive action reinitialize

Thank you for rating helpful posts!

View solution in original post

4 Replies 4

nspasov
Cisco Employee
Cisco Employee

Hi there, can you try the following instead:

authentication event server dead action authorize vlan <your VLAN>
authentication event server alive action reinitialize

Thank you for rating helpful posts!

i try it

but recovery mechanism

don't work

Just to confirm, the VLAN authorization works when the server is "dead" but then the reinitialization does not work when the server is "alive" ?

Thank you for rating helpful posts!

yes , when the server is "dead" but then the reinitialization does not work when the server is "alive"

 is  "authentication event server alive action reinitialize" work on 802.1x ?