Management Out of Band with ISe Appliance

[mmisonne]

Hello,

I want to know if it is possible to use  port GigabitEthernet 1  as a managmenet port  ( Management out of Band) .

I try to configure it.

When I do that I can ping it , but I cannot do an SSH to this Ip adresse.

The errror message is : "The remote system refused the connection."

Why doesn't it work ?

( Note that it works on an Prime appliance which is pretty the same.)

Here is my config

+++++++++++++++++

ZZSDC2ISE3/admin# sh run
Generating configuration...
!       
hostname ZZSDC2ISE3
!       
ip domain-name resource.local
!       
interface GigabitEthernet 0
  ip address 172.26.58.138 255.255.255.240
  ipv6 address autoconfig
!       
interface GigabitEthernet 1
  ip address 172.26.200.62 255.255.255.0
  ipv6 address autoconfig
!       

+++++++++++++++++++++

Miche Misonne

[Antoine KMEID]

Hello Michel

You cannot for the moment

Management is restricted to Gig0

You can refer to this document for better understanding

http://www.cisco.com/en/US/docs/security/ise/1.1.1/installation_guide/ise_app_e-ports.html

Tony

[jan.nielsen · Accepted solution]

This will likely be possible in version 1.2, for now only gig0 can be used for management.