Hi, I have a lab where I have a virtual Cisco ISE 2.1 and when I set it up I configure Gig 0 for administration and radius authentication for the MGMT net 10.66.x.x, and when I want to use External AD authentication from the Same ISE I need it to have an interface on our server vlan since we do not want oob mgmt vlan to have any connection to server vlan.
Easy ? might be, but when I move one of the virtual NICs to server vlan , and try to configure an IP on the Gig 1-3 interface on the ISE the device wont take the configuration at all. it says it applies it but when you do a show running-config after the interface configuration is still as it was before, only ipv6 enabled and on autconfig, no ipv4 config at all... Im starting to think this is some Alfa code feature that is still there, or is there some crucial step I have missed like do I need to turn some services of before configuring an interface ip ?
