NAC appliance local authentication not working

[dragnia_s]

Hi,

i am trying a test scenario for NAC. it is oob virtual gateway

I get the login page when i try to access the web but when i try to authenticate to the local db i don;t receive an error message and i remain on the authentication screen.

I listened with tcpdump on both interfaces. on the untrusted side i see traffic but on the trusted side no diffrence in traffic appears(but maybe this is normal)

can someone please help with the detailed steps the authentication follows

not just host->nas->nam(localdb)

or some ideas

Thank you!

[ahmedelfeki · Accepted solution]

check for the teporary certificates that you generated and set the FQDN field to the nas ip address and so with the nam

[dragnia_s]

Thank you, that was the issue.

[flitcraft33]

I doubt this will help, but here goes. I seem to remember a similar issue here, and I went into my browser's proxy settings and turned them off. Then I could authenticate, but not browse the web. So after authenticating I turned them back on and it was fine. There is a tab on the NAC Device Management > Clean Access Servers > >Advanced> Proxy where you can tell clean access about a proxy server, but I don't know if that's relevant.

I assume you have verified that your local user ID works by testing the auth server with it and that it has a profile that allows you to go someplace.