NMAP Probe on Cisco ISE

[SaintEvn]

Hi,
For NMAP probe in cisco ISE profiling , do I need any configuration for access-switch ?

Is SNMP configuration needed for NMAP? 

Thanks

[balaji.bandi]

what is the goal here?

it uses SNMP configuration already in ISE configured, if you doing against profile?

[SaintEvn]

I would like to use NMAP scan information in custom profiling like OS Scan, Common port Scan, etc.

In this case, Do I need extra configuration for NMAP on the switch side?

[balaji.bandi · Accepted solution]

As i mentioned ISE SNMP configure uses it not required any more advanced config.

[Rob Ingram · Accepted solution]

Hi @SaintEvn 

No you don't need any configuration on the switch for NMAP.

NMAP initated from ISE, directly communicates with the endpoints in order learn information used for profiling.

HTH