cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Announcements
Choose one of the topics below to view our ISE Resources to help you on your journey with ISE

This community is for technical, feature, configuration and deployment questions.
For production deployment issues, please contact the TAC! We will not comment or assist with your TAC case in these forums.
Please see How to Ask the Community for Help for other best practices.

126
Views
4
Helpful
3
Replies
Highlighted
Beginner

Not able to login in ISE through CMD prompt/Putty.

I have installed ISE 2.2,i am not able to login through putty but able to login through GUI with same admin user.how can be login through cmd /putty ?

Everyone's tags (4)
3 REPLIES 3
Highlighted
Advocate

Re: Not able to login in ISE through CMD prompt/Putty.

During setup, you are prompted if wish to enable SSH service,  Check SSH settings in "sh run" under CLI and verify 'service sshd enable" is configured.  There are additional security options under 'service sshd <parameter>".

Highlighted
Cisco Employee

Re: Not able to login in ISE through CMD prompt/Putty.

Use SSH:

$ ssh admin@198.18.133.27

admin@198.18.133.27's password:

Last login: Tue Mar 27 03:01:55 2018 from x.x.x.x

ise/admin#

Highlighted
Cisco Employee

Re: Not able to login in ISE through CMD prompt/Putty.

If this is not a new installation, it's also possible that the CLI and GUI passwords are different since these are NOT automatically synced after the initial creation from the setup wizard. If the CLI admin password has been changed and lost, you might need to reset the CLI password using the recovery options listed in the link below.

ISE: Password Recovery Mechanisms - Cisco