cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
519
Views
4
Helpful
3
Replies

Re: ISE map AD group to Endpoint Group

Anthony Poli
Level 5
Level 5

I have another iteration of this setup I am trying to make work.

Single SSID w/ hotspot portal for guests containing an AUP to accept for internet access.  I'd like for this page to also include either a login for my two BYOD AD user groups (corp and vendor) or a link on that page which takes them to that login portal.  I am able to embed a link on this initial portal that takes them to another login portal I created, however after they enter creds nothing further happens.  That link-enabled portal is not tied to a AuthZ policy, so I am wondering if that's where it breaks down.  I cant figure out how I would write that policy.

Overall, my AuthZ policies are similar to the one above with the exception that the policy I marked as #1 (posted in earlier thread this branched from) is hotspot instead of CWA.

Appreciate any thoughts on this.

Anthony

3 Replies 3

Jason Kunst
Cisco Employee
Cisco Employee

Have you seen this?

https://communities.cisco.com/docs/DOC-64018?mobileredirect=true#jive_content_id_Special_Flows

There is a get quick access hotspot with credential login

Dang, guys!  Both great suggestions.  I'll let y'all know how it turns out.  Thanks again!