cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
423
Views
0
Helpful
0
Replies

redondance de cisco ise: l'agent nac ne s'affiche pas

Bonjour,

J'implemente actuellement la solution cisco ISE avec 4 serveurs deux Admin/Monitor nodes et deux Policy Nodes. Lorsque je déconnecte le Policy node principal, l'agent NAC ne s'affiche plus à la connexion d'un utilisateur. j'ai configuré la redondance des serveurs Radius sur mes Switch d'accès (

radius-server retry method reorder). dans l'host discovery de l'Agent NAC, il est mis les deux policy nodes séparés par un point virgule (svr-politc-ise01.xxx.ci; svr-polidr-ise01.xxx.ci). Pouvez-vous m'aider?

Hello,

I currently implements the solution Cisco ISE with 4 servers, two Admin / Monitor Nodes and two Policy nodes. When I disconnect the main Policy node  NAC Agent is no longer displayed. I configured the RADIUS server redundancy on my Access Switch (radius-server retry method reorder). in the host discovery of the NAC Agent, it is both set policy nodes separated by a semicolon (politc-svr-ise01.xxx.ci; polidr-svr-ise01.xxx.ci). Can you help me?

0 Replies 0
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: