Remote agent and multiple ACS

[s-connolly]

Can you setup a remote agent to be used by more then one ACS. I have two ACS servers V4.1 and I would like to have two remote agents and have either ACS access both remote agents.

During the remote agent install it request one IP of a ACS.

thanks

Steve

[JOOST HAGE]

Yes, this should be possible. After initial setup you can add additional ACS servers in the CSAgent.ini file.

Add the additional ACS servers to the PermitedClients option

More details can be found at http://www.cisco.com/en/US/products/sw/secursw/ps5338/products_installation_and_configuration_guide_chapter09186a0080193a9b.html#wp838093

Joost

[Nashja]

@JOOST HAGE  Could you please show example of how to configure more than ACS to a remote agent. I tried to add ConfigProviderHost in CSAgent.ini as follows :

ConfigProviderHost=192.168.1.x ,192.168.2.x

But it's not work. The remote agent didn't got any log.

Please advise.

Thank you.