Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
There are many error status on the package status as the attachment. And, I cannot access GUI that show the error message "no route and no API found with those values" I tried to re-build, re-deploy, undeploy the package on CLI. Moreover, I tried to ...
My DNAC 1.3, After shutdown by using command “sudo shutdown -h now” and turn on the appliance on the next day, I wait for 1 hour but I still cannot access GUI on DNAC appliance that show the log “Service Error, An invalid response was received from t...
My DNAC version 1.3 cannot configure Layer 2 hand-off on Border node (C9500-24Y4C) that showed “Provisioning failed due to invalid parameter. Border L2 hand-off is not supported on device XXXX. I tried to create new IP Pool, re-provision Border node ...
I used FMC on VMWare version 6.2.3 (build 83) to control FTD 2110. I have the Malware license and installed to FMC already.
I tried to turn on AMP for network but no luck, it could not connect to any Cloud (US, EU, APJC).
I already tried to trou...
Hi All,
Due to I change my CUCM to the new CUCM server, I have to reset my IP Phone to register with the new CUCM server (I use the same IP as the existing one). I don't want to go onsite to perform hardware reset on IP Phone.
Does anyone have ot...
Hi Tomas, Sorry for confuse information. I mean I tried to rebuild all packages by using "maglev package rebuild --package-all" command (I could not remember the exact syntax), not rebuild IOS. The service contract is not start yet. So, I could not o...
Hi Mike, Thank you for the recommendation. The connection between Cisco DNAC appliance and DNA cloud is OK. I checked it already. By the way, all packages are deployed already but they got the error during the deployment. Do you know how to factory r...
Hi Nathan, Thank you for your support. I have one question. Can I configure Layer 2 handoff manually on Border node. I used to configure Layer 3 handoff manually on Border that work fine. Do you have the Layer 2 handoff configuration template. Thank...
Hi BB,
Both of FMC & FTD can access api.amp.sourcefire.com
admin@FTD:~$ telnet api.amp.sourcefire.com 443Trying 52.73.183.156...Connected to api.amp.sourcefire.com.Escape character is '^]'.
admin@FMC:~$ telnet api.amp.sourcefire.com 443Trying 5...
