cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

This community is for technical, feature, configuration and deployment questions.
For production deployment issues, please contact the TAC! We will not comment or assist with your TAC case in these forums.
Please see How to Ask the Community for Help for other best practices.

2004
Views
0
Helpful
2
Replies
RSundstrom
Beginner

% SSH connect error when "show repo xxxx" in Cisco ISE

Hello,

I just upgraded to ISE 1.2 and lost access to my two repositories. This was expected.

I was able to get one of my repositories back by deleting and recreating it. I created it in the GUI and then ran the command "crypto host_key add "IP address of repo server".

When I deleted and recreated the second repo but still can't run a backup to it. I tried running the CLI command "Show Repo Backup" and I get a response " % SSH connect error". I have run the "crypto host_key add" command for this repo, also.

I searched the Cisco Forum and even Googled it with minimal results.

Any ideas?

2 REPLIES 2
Robert Salazar
Cisco Employee

What type of repository are you using? Solarwinds?

melanie.pflaume1
Beginner

Hi,

i have the same error.

does there exists any solution to this problem?

regards

Content for Community-Ad