04-26-2010 04:20 AM - edited 03-10-2019 05:05 PM
Hi,
i can not connect with telnet on the ACS Server. I have two of this ACS and one is ok and the other not :-(
Maybe is a config problem of the ACS but i see not the differenc of this two ACS.
regards,
muratayas
04-26-2010 06:44 AM
Hi,
TELNET access is restricted on the appliance. To troubleshoot it, you need to console in using your admin user. Once in issue command "show" and hit enter. The output will give you information about the issue. (Make sure all services are running)
http://www.cisco.com/en/US/docs/net_mgmt/cisco_secure_access_control_server_for_solution_engine/4.1/installation/guide/solution_engine/instalap.html#wp1024038
Regards,
~JG
Do rate helpful posts
04-28-2010 05:53 AM
Hi JG,
i connectet to the serial port and make the show command. All process is running and shows good.
Cisco Secure ACS: 3.3.2.2
Appliance Management Software: 3.3.2.1
Appliance Base Image: 3.3.1.6
CSA build 4.0.1.543.2: (Patch: 4_0_1_543)
Session Timeout: 10
Last Reboot Time: Fri Mar 19 10:50:39 2010
Current Date & Time: 4/28/2010 13:42:01
Time Zone: (GMT+01:00) Amsterdam, Berlin, Bern, Rome, Stockholm, Vienna
NTP Server(s): x.x.x.x
CPU Load Free Disk Free Physical Memory
7.69% 18.0 GB 726 MB
Appliance IP Configuration
DHCP Enabled. . . . . . . . . . .: No
IP Address. . . . . . . . . . . .: x.x.x.x
Subnet Mask . . . . . . . . . . .: x.x.x.x
Default Gateway . . . . . . . . .: x.x.x.x
DNS Servers . . . . . . . . . . .: x.x.x.x
CSAdmin running
CSAuth running
CSDbSync running
CSLog running
CSMon running
CSRadius running
CSTacacs running
CSAgent running
that is not the problem but wath?
regards,
mayas
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide