User Access -
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-27-2012 09:08 AM - edited 03-10-2019 07:27 PM
We are in the process of connection our networks to an outside vendor. We are installing a 3925 ISR at their location and a matching 3925 ISR at ours and configiring a DMVPN connection between them. Other than putting ACL's on the router at the vendor location limiting IP's and Ports allowed, can we configure something that would force the user to Authenticate before they could access the network at our location?
- Labels:
-
AAA
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-27-2012 09:36 AM
If you are configuring a site to site tunnel to allow the traffic to come across you can consider using auth-proxy and tie that in to a radius server if you want.
Here is some documentation that covers this:
http://www.cisco.com/en/US/products/sw/secursw/ps1018/prod_configuration_examples_list.html
Thanks,
Tarik Admani
*Please rate helpful posts*
