Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are in the process of connection our networks to an outside vendor. We are installing a 3925 ISR at their location and a matching 3925 ISR at ours and configiring a DMVPN connection between them. Other than putting ACL's on the router at the ven...
We have our Primary site and Backup site connected through varoius routers and a PIx at each site. From our Backup Site we can connect to the two Physical host servers of the SQL CLuster, But are unable to connect to the Virtual Address. After doin...
Hello, we are looking for a hardware/software solution that can simulate a WAN or two that would allow us to test our hardware setup/config before deploying it in the production environment. I've looked at PacketStorm products and was wondering if a...
We are in the process of replacing a PIX with a 2821 running the VPN feature set. When we put in place and terminte a VPN tunnel to the PIX at the far end, then connection and tunnels appears to come up fine, but we seem to be having some issues wit...
I'm having some trouble with my configs. The crypto sessions appear to active, but I'm unable to get traffic accross for one side to the other. Can someone point me in the right direction.
Sorry for the confusuion about our network we are trying to simulate. Our primary network now consists of 6 sites that all have a router provided by the telco. These have a 10/100 ethernet connection that we connect to. Our backup network is a Con...
I've attached a less snipped version of each routerTo casu ethe tunnel to go down I'm disconnectin a cable in between a couple of routers simulating the WAN. The rpimary side initiates all calls
