- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-15-2019 09:20 PM
Hi,
With Windows native 802.1x supplicant and "User or Machine authentication" enabled, only machine authentication started when a user establish a remote desktop session to an existing connected endpoint. Beside using AnyConnect NAM, do we have any option to authorize an endpoint based on user identity. In our current setup, machine authentication will receive a different set of authorization policy. Our objective is to maintain authorization policy based on previously logged on user identity.
Thanks
Wing Churn
Solved! Go to Solution.
- Labels:
-
Identity Services Engine (ISE)
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-16-2019 05:18 PM
You may also try chaining DOT1X machine auth with Easy Connect.

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-16-2019 02:27 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-16-2019 05:18 PM
You may also try chaining DOT1X machine auth with Easy Connect.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-18-2019 07:28 PM
Hi Hsing,
Would you mind sharing any document around chaining 802.1x with Easy Connect?
Thanks
Wing Churn
