cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Announcements
Choose one of the topics below to view our ISE Resources to help you on your journey with ISE

This community is for technical, feature, configuration and deployment questions.
For production deployment issues, please contact the TAC! We will not comment or assist with your TAC case in these forums.
Please see How to Ask the Community for Help for other best practices.

461
Views
0
Helpful
1
Replies
Beginner

VG202XM as dot1x supplicant

Hello Community,

i have some troubles about my VG202XM as dot1x supplicant. I have found some informations to configure a normal router as a dot1x supplicant. But this commands are not work.

The tested way was:

en

conf t

dot1x credentials test

username test1

password test2

exit

interface fa 0/1

dot1x pae supplicant

Command rejected: Dot1x is not supported.

Dot1x is supported only on Ethernet interfaces configured in Access, Routed or Private-vlan Host Mode.

I can not type "switchport mode access" because it is a router not a layer 3 switch. I had add on this interface a ip address but there was the some message. I have no idea ....

ip routing <- is set

I hope anybody can help me.

1 REPLY 1
Highlighted
Beginner

Hi Markus, they were opened a

Hi Markus,

 

they were opened a TAC-Case with an Defect-id.

#CSCus38551

 

best regards 

Andi