What is difference of where to put ip address in between group-policy and tunnel-group in SSL vpn ?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-25-2015 11:08 AM - edited 03-10-2019 10:51 PM
Dear All
I reviewed several SSL VPN configuration examples. After setting up ip local pool for the ssl vpn users, some example's configuration put it under the group-policy, while other put it under the tunnel-group. My question is what is difference between the two configuration ?
Thank you
- Labels:
-
AAA
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-25-2015 01:28 PM
One reason for doing that, could be to assign from different ip pools, depending on what group-policy your users land in, which could be assigned dynamically by an authentication server based on AD group membership.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-27-2015 03:06 PM
Thank you for your reply. Can you tell a little more about this ? Thank you again
