Network Access Control

Hi guys, We have two ACS servers( ACS01, ACS02) running on VM( with latest 5.7 version), both contain different sets of data. we want to keep those two servers in distributed mode(ACS01 as primary and ACS02 as secondary) with full replication, if i s...

I have a Cisco 3560 with the following configuration on the first two interfaces:interface GigabitEthernet0/1 description === Test PC=== switchport access vlan 10 switchport mode access ip access-group ACL_DEFAULT in authentication event fail action ...

So i encountered a strange problem the other day after changing the Native/Mgt vlan on a switch. It was set to 1 and i changed it to 10. after that none of the PC's could get DHCP addresses. restarted the router and switch and pc's to no avial. they ...

What are the custom attributes alcatel-lucent omniswitch expect when using tacacs+ for authentication/authorization to set user privileges?

I am running Cisco ACS 5.1 802.1x with certificate based authentication for Wired and Wireless connections. The issue that I am having is that when a user comes in from home with their laptop the wireless connection works, they pass the authenticatio...

Hi Team:Good day,Is there any procedure or article . How we can authorized & authenticate the Fortigate devices with Cisco ACS 5.2.I can follow below KB but no success.https://supportforums.cisco.com/discussion/11864991/tacacs-authentication-and-fort...

Hi, How to combine two access policies into one so that all devices will be able to authenticate against that policy. Two policies have few common protocols. Thanks

I am upgrading about a dozen nodes (various personas) from 1.3 to 1.4.  After successfully upgrading every node I am locked out of the CLI admin login.  This is consistent with all personas.  The logins all worked before upgrade (obviously since we w...

In ACS 5.4, the CLI command ip name-server, you can specify up to 3 IP address for DNS. It's my understanding the first IP address is the first choice, the 2nd IP is the 2nd choice, etc. I had an issue where connectivity to the first IP address of th...

Hi, I have a Radius server wich has to authenticate users in order to allow them a connection on routers. In this case, each router is a NAS(Network Access Server). A fallback method, has been defined in startup&running configuration.I try to find a ...