cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
542
Views
0
Helpful
1
Replies

Windows OS compatibility for endpoints in ISE

manasjai
Cisco Employee
Cisco Employee
Hello Team,
I need your help in getting information on ISE compatibility for attached endpoint windows OS in my customer's Network. I checked the compatibility matrix below but could not find support for the OS highlighted in yellow in the attached sheet. The ones in blue are servers and I don’t plan to enable Dot1x on servers but yellow ones I am concerned about.
 
Interestingly, some of them I see in ISE under "Windows All" like Vista, but I don’t see in the matrix. Does this mean Anyconnect NAM/Native supplicant is not supported on the OS marked in yellow?
  
Thanks,
Manasi
1 Accepted Solution

Accepted Solutions

Jason Kunst
Cisco Employee
Cisco Employee
If it has a stable supplicant then it should work with dot1x. Nothing special. we don't test every OS and combination.

ISE will not show you what runs on anyconnect, that's an anyconnect chart. However NAM is only for windows.

View solution in original post

1 Reply 1

Jason Kunst
Cisco Employee
Cisco Employee
If it has a stable supplicant then it should work with dot1x. Nothing special. we don't test every OS and combination.

ISE will not show you what runs on anyconnect, that's an anyconnect chart. However NAM is only for windows.