639
Views
0
Helpful
1
Replies

Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-03-2019 02:30 AM
Hello Team,
I need your help in getting information on ISE compatibility for attached endpoint windows OS in my customer's Network. I checked the compatibility matrix below but could not find support for the OS highlighted in yellow in the attached sheet. The ones in blue are servers and I don’t plan to enable Dot1x on servers but yellow ones I am concerned about.
Interestingly, some of them I see in ISE under "Windows All" like Vista, but I don’t see in the matrix. Does this mean Anyconnect NAM/Native supplicant is not supported on the OS marked in yellow?
Thanks,
Manasi
Manasi
Solved! Go to Solution.
Labels:
- Labels:
-
Identity Services Engine (ISE)
1 Accepted Solution
Accepted Solutions

Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-03-2019 12:12 PM
If it has a stable supplicant then it should work with dot1x. Nothing special. we don't test every OS and combination.
ISE will not show you what runs on anyconnect, that's an anyconnect chart. However NAM is only for windows.
ISE will not show you what runs on anyconnect, that's an anyconnect chart. However NAM is only for windows.
1 Reply 1

Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-03-2019 12:12 PM
If it has a stable supplicant then it should work with dot1x. Nothing special. we don't test every OS and combination.
ISE will not show you what runs on anyconnect, that's an anyconnect chart. However NAM is only for windows.
ISE will not show you what runs on anyconnect, that's an anyconnect chart. However NAM is only for windows.
