Wired MAB using ISE 2.6 and Meraki

[TerranceBlackman3341]

Hi,

Are there any setup/configuration/step-by-step guides that detail how to setup Wired MAB using ISE 2.6 and Meraki?  I'm new to ISE and unfortunately, the documentation (https://community.cisco.com/t5/security-documents/how-to-integrate-meraki-networks-with-ise/ta-p/3618650#toc-hId-888921786) that I have found is a bit on the dated side.

Thanks,

Terrance

[thomas]

But did you actually try it and did it fail to work for you? If so, what is missing or the error?