03-02-2012 09:03 AM - edited 03-10-2019 06:52 PM
Hi,
It's possible to integrate my Wireless Network ( Ruckus ) with Cisco ISE , using RADIUS to authenticate and posture (checking paths, antivírus, etc ) ?
Best Regards,
Jean Tomáz.
12-17-2012 12:28 PM
I apologize as I do not have an answer to this but am certainly looking for an answer as you are. Have you gotten anything from anyone about this?
12-17-2012 01:36 PM
Hi,
For basic user authentication you should be covered. However with respect to posturing there are some additional featuers (i.e CoA) which are used to instruct the wireless device how to handle sessions. ISE officially supports only Cisco wireless solutions per the Supported Network Devices section in the release notes.
There are other vendors that are working to support the ISE product but you may need to post this question over to Ruckus.
Here is an article regarding aruba and ISE integration with an overview from aawoland that will give you a better idea.
https://supportforums.cisco.com/thread/2145490
Thanks,
Tarik Admani
*Please rate helpful posts*
03-25-2015 03:06 PM
Jean:
Did you get a positive answer from Cisco or Ruckus?
At current time, compatibility table from ISE 1.3 just indicate Aruba as the only one third party Wireless Controller, that is compatible with ISE.
Regards.
03-31-2015 11:48 PM
posture service not supported on third party WLC
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide