It is vsat connectivity............... every link is coming throughmodem to switch & then going to fe port of router ...in every remote side.................
every site having same setup.shown in diagram..............we have 40 sites....................... every site having one router & two c& ku band modem...........
In this scenario we have two remote sites (remote side 1 & remote side 2) which is connecting on IP GATEWAY .
Working style of modem:-
we are using c band modem & ku band modem (supports Rip V2).One end of both the modem is connected to switch & another end is communicating over satellite freq with hub BASED IP GATEWAY.
I
Requirement
1.If packet is going through wan1 then return path should be wan 1. If forward path is wan 1 then return path should be wan1. Remote side 1 to remote side 2 communication is given below.
2.Means remote side 1 cband modem >>>>>>huB BASED IP GATEWAY ) >>>>then it is going on remote side 2 c band>>>& reverse should be in the same band means C band....
3. i would like all the video & data traffic translated to c band & in case of primary link down C band traffic should be translated on KU band.
FOR VIDEO & DATA, PRIMARY BAND IS C BAND & KU BAND IS SECONDARY.
4. In case of voice , i would like all the voice traffic translated to the Ku band & during primary link down KU band traffic should be translated on C band.
For voice , KU Band is primary & C band is secondary.
5.C band is working in star topology (hub & spoke)& KU band is working in mesh topology.
And we have 40 sites which is connecting through cband over star topology & same 40 sites are also connecting tbrough k band over h topology................it is vsat conectivity .......so please provide me better solution
