Hello @moman62
Regarding the output, your switch was previously part of a stack, and the Giga 6/0/x interfaces were assigned to switch number 6 in that stack. Now that you have changed the interfaces, it suggests the switch is operating as a standalone unit or has been renumbered within a new stack...
However, the old Gi 6/0/x interfaces are still showing up, which likely means the switch is retaining the previous stack member configuration. To remove these interfaces, you should first check the switch stack configuration to see if any remnants of the old stack setup remain. If the switch was once in a stack and is now standalone, clearing the old stack member information and reloading the switch should resolve the issue. If the interfaces still persist, a factory reset may be necessary to completely remove the old stack configuration...
Best regards
.ı|ı.ı|ı. If This Helps, Please Rate .ı|ı.ı|ı.
