Add devices manually

[mserranocisco]

I'm new on version 3.1, and I don't understand how does it work.

I want to add nodes only manually, I don't want to use Seed Devices. I add them from CS>Device Management, they say me nodes had been added properly, but they appear always as Unreachable. Ping and snmpwalk returns OK.

Should I configure something on Device Discovery?

[Marvin Rhoads]

Have you entered the proper credentials for the devices in the Device and Credential Repository (DCR)?

Refer to Chapter 5 of the Common Services User Guide:

http://www.cisco.com/en/US/docs/net_mgmt/ciscoworks_common_services_software/3.2/user/guide/dcr.html

Hope this helps. Please rate helpful posts.

[mserranocisco]

Yes, I supose...

I have defined Default Credentials and checked Use Default Credentials when adding devices.

Devices added appear properly on CM, but not anywhere else.

I have added them from CS>Device Management, but list is empty, if I try to add a node again, it says it exists... I don't understand anything 😞