Automate_bounce the switchport_AP

[NDP]

Is it possible to configure Cisco prime to bounce the switch port if the specific switch port status is connected and CDP detected AP, but, AP is not associated to WLC. 

We get alarms in Cisco prime everyday that AP got disassociated. prime will also give us information about switchname and port it is connected. 

most of the alarms are resolved by resetting the connected switchport

We normally bounce the switchport in following conditions

(1) switch port status is up/up

(2) CDP detected AP but with APdefault name ( not with the one which we named)

the AP got associated after bouncing the switchport and CDP showed the configured AP Name.

Can we automate this with Cisco prime itself.

Thanks in advance

[Mark Malone]

Hi

Prime 3.0 or above with compliance enabled should be able to do that as you can set an action after it has ran its checks in compliance , it probably wont be easy to setup though compliance can be a bit tricky , in rule inputs and conditions and actions section of compliance in policies is where you will see it

an eem script maybe easier to setup