08-21-2009 12:30 PM
I have an issue with CM Visualization when I display the layer 2 view. I have a device in another state that is connected to our WAN via a MPLS network that does not support CDP traffic. That said the CM Visualization applet creates a link across the WAN between two devices that are NOT neighbors.
Device1#Sh cdp neighbors
Capability Codes: R - Router, T - Trans Bridge, B - Source Route Bridge
S - Switch, H - Host, I - IGMP, r - Repeater, P - Phone
Device ID Local Intrfce Holdtme Capability Platform Port ID
30329.00001.1.RT01.rpc.local
Gig 0/24 155 R S I 2851 Gig 0/0
30329.00001.1.SW03.rpc.local
Gig 0/25 122 S I WS-C3560-2Gig 0/1
30329.00001.1.SW02.rpc.local
Gig 0/23 165 S I WS-C3560G-Gig 0/48
Device2# sh cdp neighbors
Capability Codes: R - Router, T - Trans Bridge, B - Source Route Bridge
S - Switch, H - Host, I - IGMP, r - Repeater, P - Phone
Device ID Local Intrfce Holdtme Capability Platform Port ID
75663.00425.1.RB01.rpc.local
Fas 0/47 143 T AIR-BR1310Fas 0
75663.00425.1.SW01.rpc.local
Fas 0/48 159 S I WS-C3560G-Gig 0/47
How is this possible? Can I repair it? not a show stopper but certainly an annoyance.
Thanks,
Rob
08-21-2009 12:45 PM
What version of Campus Manager is this?
08-21-2009 12:47 PM
Campus Manager 5.1.0
08-21-2009 01:15 PM
That's what I thought. If you upgrade to 5.1.3 from Common Services > Software Center > Software Update, then reinitialize the topology portion of the ANI database, this problem should go away:
NMSROOT/bin/perl NMSROOT/campus/bin/reinitdb.pl
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide