Cisco 4451 Subslot Configuration

[markhughes]

I installed a module in a 4451 Router.  I can see the new subslot as shown below.  I have activated it as shown by the last command.  The issue is if I do a show interface... command I can't see it there, can't see it with a show run and can't get to it with a conf t: int gi 1/0....

Need assistance in locating the interfaces so I can configure this new module. 

CH01-INET-4451#show diag subslot 1/0 eeprom
SPA EEPROM data for subslot 1/0:

Product Identifier (PID) : SM-X-16G4M2X
Version Identifier (VID) : V02
PCB Serial Number : FOC2....
Hardware Revision : 1.0
CLEI Code : INUIAH0EAB
CH01-INET-4451#show diag subslot 1/0 eeprom detail
SPA EEPROM data for subslot 1/0:

EEPROM version : 4
Compa.....

CH01-INET-4451#hw-module subslot 1/0 start

[Mark Elsen]

            >...CH01-INET-4451#hw-module subslot 1/0 start
   - Check the logs on the 4451 after using this command too 

 M.

[Georg Pauwen]

Hello,

does the module show up when you issue the 'show platform' command ? Did you try to connect with the commands below (depending on your slot/subslot):

4451# hw-module session slot/card
4451# hw-module session 0/1 endpoint 0

Check the document linked below for reference:

https://content.cisco.com/chapter.sjs?uri=/searchable/chapter/content/dam/en/us/td/docs/routers/access/interfaces/sm/hardware/installation/guide/SMX16G4M2X-book.html.xml