cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
793
Views
0
Helpful
2
Replies

Cisco 6500 series..netflow configuration

linker.team
Level 1
Level 1

In Cisco 6509, while setting the flow mask to interface-full mode I get the following error..

% Unable to configure flow mask for ip protocol: interface-full. Reset to the

default flow mask type: none

Is it a limitation?

2 Replies 2

Jan Nejman
Level 3
Level 3

Hello,

some features as NAT may require certain flow mask. Do you using some special features (NAT,IPSec,bridging)?

Please, could you send me your current flowmask. (show mls netflow flowmask)

or in better case the full configuration.

Kind regards,

Jan Nejman

Caligare, Co.

http://www.caligare.com/

Hi Jan,

Here are the outputs.

#sh mls netflow flowmask

current ip flowmask for unicast: null

current ipv6 flowmask for unicast: null

Also SUP 720 runs 12.2(18)SXF8 IOS.

Do you have any insights on this.

Thanks

Raj